Bel Canto PHONO Preamplifier
The PHONO preamp will unleash tremendous dynamics and resolution to your listening experience.
Optimized two stage architecture
Low noise 40dB input stage
Custom discrete output stage with adjustable gain
Precision RIAA network
High drive output buffer
Low noise multi-stage channel independent power supply
Ground optimized PCB layout
PHONO Preamplifier Features
DSSA, Discreet Single Stage Amplifier
This is a very fast, low noise amplifier with a single-stage folded cascode architecture and over 500mA of peak current output capability. It maintains very low constant distortion levels through the audio band because of its high open-loop bandwidth. The DSSA module brings a further element of dynamic resolution and contrast to the e.One Phono. The vertical modular design permits a tight, efficient Printed Circuit Board (PCB) layout that combines the best of IC based and discrete component design.
Gain and Resistance Customization
The PHONO can work with a wide variety of cartridges by adjusting the dip switches for gain and resistance on the back of the unit.
PHONO SPECS
Bandwidth: 1Hz-50KHz
RIAA Accuracy: 20Hz-20KHz +/- 0.2 dB
Signal to Noise Ratio 40 dB gain: >80 dB A weighted, re 5mV RMS in
Distortion @ 2 Volt RMS/1KHz: <0.01%
Input Impedance: Adjustable 31 to 47k (View dip switch alignment)
Gain Level Options: Adjustable 38dB to 60dB (View dip switch alignment)
General:
Power On usage: 10W
Power Off usage: 0.0W
Internally Set Operating Voltages: 100-120VAC or 230-240VAC 50/60 Hz
Size: 8.5 x 3.5 x 12?, 216 x 88 x 305mm (W x H x D)
Weight: 10lbs, 4.5Kg
